pulse operation การใช้

• This magnetron was designed for pulsed operation at a wavelength of 16 cm.
• The power supply is switched on only a very short time ( pulsed operation ).
• Well-designed circuits pay attention to the ESR, ripple current rating, pulse operation, and temperature rating of capacitors.
• Density is increased through a pulsed operation that compresses the fuel, heating the plasma, just as compression heats an ordinary gas.
• In such applications, a control grid is typically introduced between the TWT's electron gun and slow-wave structure to allow pulsed operation.
• Most magnetic confinement schemes also have the advantage of being more or less steady state, as opposed to the inherently pulsed operation of inertial confinement.
• In the intermediate case ( neither cw, nor short pulse operation ), the rate equations for relaxation in the optical medium must be considered together.
• In addition, German-educated Yoji Ito, leader of the Navy delegation, was able to obtain information from the host on the MRU's pulsed operation.
• An overview of different circuit concepts for the pulsed operation of DBD optical radiation sources is given in " Resonant Behaviour of Pulse Generators for the Efficient Drive of Optical Radiation Sources Based on Dielectric Barrier Discharges ".
• While a later patent ( 1925 ) describing " pulse operation for low-pressure supercharging " is considered his landmark, due to B點hi's invention the year 1905 is thus acknowledged as the birth of the turbocharging era.
• More recently, Raman lasing has been demonstrated in silicon-based integrated-optical waveguides by Bahram Jalali's group at the University of California in Los Angeles in 2004 ( pulsed operation ) and by Intel in 2005 ( continuous-wave ), respectively.
• However, stellarators, unlike tokamaks, do not require a toroidal current, so that the expense and complexity of current drive and / or the loss of availability and periodic stresses of pulsed operation can be avoided, and there is no risk of toroidal current disruptions.
• As with all RF connectors the safe power handling is determined by the heating and subsequent oxidation of the centre'pin'for continuous operation at high frequencies, and by voltage breakdown between inner and outer at lower frequencies, or short pulse operation, and for reliable high power operation, connectors must be assembled with careful attention to cleanliness and alignment.
• It is IMO a " simple " matter of connecting the " Normally Open " contacts of the relays on the receiver board to the two pairs of points on the phone's PCB . Whether pulsed operation is long enough to open the front door, you will have to try out . ( or do you dial 6 to do this-- I cant remember ) Also, you need some power for the reciever.